Introduction To Square Tube Products

Jun 02, 2023

Also known as square and rectangular cold formed hollow steel, abbreviated as square tube and rectangular tube, with codes F and J respectively
1. The allowable deviation of the wall thickness of rectangular pipes shall not exceed 10% of the nominal wall thickness when the wall thickness is not greater than 10mm, and shall not exceed 8% of the wall thickness when the wall thickness is greater than 10mm, except for the wall thickness of corner and weld areas.
2. The typical delivery length of square tube is 4000mm-12000mm, with the majority being 6000mm and 12000mm. Square rectangular tubes allow delivery of short and non fixed length products not less than 2000mm, and can also be delivered in the form of interface tubes. However, the purchaser should cut off the interface tubes when using them. The weight of short and non fixed length products shall not exceed 5% of the total delivery quantity, and for square tubes with a theoretical weight greater than 20kg/m, it shall not exceed 10% of the total delivery quantity
3. The bending degree of square tube shall not exceed 2mm per meter, and the total bending degree shall not exceed 0.2% of the total length