Suggestions On The Peeling Method Of 3PE Anti-corrosion Coating

Dec 04, 2023

At present, in the maintenance process of gas pipelines, the peeling method of 3PE anti-corrosion coating is proposed based on the analysis of the structure and coating process of 3PE anti-corrosion coating [3~4]. The basic idea used to peel off the 3PE anti-corrosion coating on steel pipes is to create external conditions (such as high-temperature heating) to destroy the adhesion of the composite structures of the 3PE anti-corrosion coating, so as to achieve the purpose of peeling off the steel pipe.
During the coating process of 3PE anti-corrosion coating, the steel pipe needs to be heated to above 200°C. However, if the temperature is too high, the following problems will occur: the epoxy powder curing reaction is too fast, the powder melts insufficiently, and the film formation is poor, which will reduce the bonding ability with the steel pipe surface; the epoxy resin functional groups are excessively consumed before adhesive coating , partially or even completely losing the chemical bonding ability with the adhesive; the sintered epoxy powder layer may be slightly charred, manifesting as darkening and yellowing in color, causing the coating to fail the peeling inspection. Therefore, when the outside temperature is higher than 200°C, the 3PE anti-corrosion coating is easier to peel off.
After the gas pipeline is buried underground, due to municipal engineering needs, the buried pipeline needs to be cut or modified; or when a gas leak occurs and emergency repair work is required, the anti-corrosion layer must first be stripped off before other pipeline operations can be carried out. At present, the stripping operation process of 3PE anti-corrosion coating on gas steel pipes is: construction preparation, pipeline pretreatment, heating treatment, 3PE anti-corrosion coating stripping, and other construction work.
① Construction preparation
Construction preparations mainly include: arrival of construction personnel and facilities, pressure reduction treatment of emergency pipeline repairs, excavation of working pits, etc. The construction equipment for stripping 3PE anti-corrosion coating mainly includes acetylene gas cutting gun, flat shovel or hand hammer.
② Pipeline pretreatment
Pipeline pretreatment mainly includes: determining the pipe diameter, cleaning the outer surface of the pipe, etc.
③Heating treatment
Use an acetylene gas cutting gun to heat the pretreated pipe at high temperature. The flame temperature of gas cutting can reach 3000°C, and the 3PE anti-corrosion coating applied to the gas pipeline can melt above 200°C. Therefore, the gas cutting gun can quickly melt the 3PE anti-corrosion coating at the point where the muzzle is aimed into a gel, making the The adhesion of the coating is destroyed.
④ Peeling off of 3PE anti-corrosion coating
Because the heat-treated coating's adhesion has been destroyed, the coating can be peeled off the pipe using mechanical tools such as a spatula or hand hammer. The effect after the 3PE anti-corrosion coating is completely peeled off is shown in Figure 1.
⑤ Other construction work
After peeling off the 3PE anti-corrosion coating, the pipeline must be cut, welded, and new anti-corrosion coating applied.
The currently used mechanical manual peeling method is slow and the peeling effect is average. Due to the limitations of construction equipment, the stripping work efficiency is not high, which directly affects the efficiency of emergency repair of gas pipelines. The limitations of construction equipment are mainly reflected in: a. The limitation of the jet flame area of the gas cutting gun results in a small melted coating area during gas cutting heating treatment; b. The limitation of the fit between tools such as flat shovels or hand hammers and the outer surface of the circular pipe As a result, the coating stripping efficiency is not high.

news-750-750

Gnee Customer visit

news-1000-800