Chemical Composition Of 16Mo3
Mar 25, 2024
- Chemical composition (melt analysis)a, %
C: 0.12-0.20 b
Si: ≤0.35
Mn: 0.40-0.90
P max: 0.025
S max: 0.020
Cr:≤0.30
Mo: 0.25-0.35
Ni: ≤0.30
Al total: ≤0.040
Cu: ≤0.30 c
a Without the consent of the ordering party, elements other than those in this table shall not be intentionally added, except for those elements that must be added in the smelting process, and harmful elements brought into the steelmaking process shall be avoided as far as possible.
b Wall thickness ≥30mm carbon content can be increased by another 0.02%.
c (Optional): To facilitate the later molding process, a lower maximum copper content may be stipulated with the agreement of the buyer and seller, and the maximum tin content may be limited.
- Heat Treatment:
Normalized or normalised rolled
Temperature: 890 - 950 °C
Cooling medium: Air

- Mechanical properties
Room temperature or low-temperature tensile properties:
16Mo3 Seamless Steel Pipe Yield strength ReH or RP0.2
|
Wall Thickness mm |
Mpa |
|
T ≤16 |
280 |
|
16<T≤40 |
270 |
|
40<T≤60 |
260 |
- 16Mo3 Chrome Moly Steel Pipes Tensile strength, Rm, Mpa: 450 to 600
Minimum elongation A, %.
| Longitudinal | Transverse |
|
22 |
20 |
- 16Mo3 Alloy Steel Pipe Impact performance (optional).
Test temperature: 20°C, minimum average absorbed energy value KV J.
| Longitudinal | Transverse |
|
40 |
27 |
- 16Mo3 Seamless Alloy Steel Tube Minimum yield strength at elevated temperatures Rp0.2 (optional):
Wall thickness, mm: ≤60
|
Temperature℃ |
Mpa |
|
100 |
243 |
|
150 |
237 |
|
200 |
224 |
|
250 |
205 |
|
300 |
173 |
|
350 |
159 |
|
400 |
156 |
|
450 |
150 |
|
500 |
146 |
- Outside diameter and wall thickness tolerances
OD: ±1% or 0.5mm whichever is greater
Wall thickness.
|
O.D. |
Wall thickness tolerance, For T/D ratio |
|||
|
≤0.025 |
>0.025 ≤0.050 |
>0.050 ≤0.10 |
>0.1 |
|
|
D≤219.1 |
12.5% or 0.4mm take the biggest one |
|||
|
D>219.1 |
20% |
15% |
12.5% |
10% |
For OD D ≥ 355.6 mm the local wall thickness tolerance is allowed to exceed 5% of the specified base.
- Tolerance of fixed-length
|
Length L |
Length Tolerance |
|
L ≤ 6000 |
0, +10 |
|
6000<L ≤12000 |
0, +15 |
|
L>12000 |
0, according agreement |



