Importance Of Preheating Before Welding And Heat Treatment After Welding
Mar 13, 2024
1. The main functions of preheating before welding are as follows:
(1) Preheating can slow down the cooling rate after welding, which is conducive to the escape of diffuse hydrogen in the weld metal to avoid hydrogen cracking. It also reduces the degree of hardening of the weld and heat-affected zone and improves the crack resistance of the welded joint.
(2) Preheating reduces welding stress. Uniform local preheating or overall preheating can reduce the temperature difference between the welded workpiece in the welding area (also known as temperature gradient). This reduces welding stress on the one hand, and on the other hand, reduces the welding strain rate, which is conducive to avoiding welding cracks.
(3) Preheating can reduce the constriction of the welded structure, especially obvious to reduce the constriction of the angle joint, with the increase in preheating temperature, the cracking rate decreases.
Preheating temperature and interlayer temperature selection is not only related to the chemical composition of steel and electrode, but also with the rigidity of the welded structure, welding method, ambient temperature, etc., should be determined after considering these factors. In addition, the uniformity of the preheating temperature in the direction of the steel plate thickness and in the weld region has an important influence on the reduction of welding stress. The width of the local preheating, should be based on the constraints of the welded workpiece, generally should be three times the wall thickness around the weld area, and shall not be less than 150-200 mm. If the preheating is not uniform, not only does not reduce the welding stress, but will appear to increase the welding stress.

2. Post-weld heat treatment
The purpose of post-weld heat treatment is threefold: hydrogen elimination, elimination of welding stress, and improvement of weld organisation and overall performance.
Post-weld hydrogen elimination treatment, refers to the low-temperature heat treatment after the completion of welding, the weld has not yet cooled to below 100 ℃. General specifications for heating to 200 ~ 350 ℃, holding 2-6 hours. The main role of post-welding dehydrogenation treatment is to accelerate the escape of hydrogen in the weld and heat-affected zone, for the prevention of low alloy steel welding to produce weld cracks is extremely effective.
In the welding process, due to the unevenness of heating and cooling, as well as the component itself to produce constraints or external constraints, in the end of the welding work, in the component will always produce welding stress. Welding stress in the component, will reduce the actual bearing capacity of the welded joint area, resulting in plastic deformation, and in serious cases, will lead to the destruction of the component.
Stress relief heat treatment is to make the welded workpiece in the high temperature state, its yield strength decreases, to achieve the purpose of relaxation of welding stress. There are two commonly used methods: one is the whole high-temperature tempering, that is, the weldment as a whole into the heating furnace, slowly heated to a certain temperature, and then held for a period of time, and finally cooled in the air or in the furnace. With this method can eliminate 80% -90% of the welding stress. Another method is the local high-temperature tempering, that is, only the weld and its nearby areas are heated, and then slowly cooled to reduce the peak of the welding stress, so that the stress distribution is relatively smooth, and play a part in eliminating the purpose of welding stress.

Some alloy steel materials after welding, its welded joints will appear hardened organisation, so that the mechanical properties of the material deteriorate. In addition, this hardened tissue in the welding stress and the role of hydrogen, may lead to the destruction of the joint. If after heat treatment, the metallurgical organisation of the joint is improved, the plasticity and toughness of the welded joint are improved, thus improving the comprehensive mechanical properties of the welded joint.





