Purpose Of Preheating Of Alloy Steel Before Welding

Mar 13, 2024

Alloy steel weldability is poor, hardening tendency, welding process weld and heat-affected zone may be some of the following problems:

(1) after welding in the weld and heat-affected zone appear hard and brittle hardened organisation, if then the larger internal stress exists, there will be cold cracks, toughness, plasticity reduction.
(2) has the tendency to appear arc crater cracks.

(3) certain alloying elements, with welding reheat cracking tendency, especially vanadium-containing, boron-containing steel is very. In order to avoid and eliminate the above defects, alloy steel needs to be preheated before welding, post-welding heat treatment.

  • the purpose of preheating before welding:

(1) preheating can reduce the cooling rate of the welded joint, which is conducive to the escape of diffusion hydrogen in the weld metal, can avoid hydrogen cracking. In the lower temperature region for welding, in order to prevent cracking, even if it is low carbon steel whose thickness exceeds 20mm must be preheated.

(2) preheating is an effective measure to prevent cold cracks, hot cracks and hardened tissue in the heat affected zone. When welding carbon steel with high carbon content, low alloy steel, heat-resistant steel, as well as ordinary low carbon steel stiffness components, due to the fast cooling rate of the weld, easy to produce in the weld and the heat affected zone of the hardened organisation, resulting in cracks. So the weldment must be preheated. Preheating can achieve the purpose of slowing down the cooling rate, which can prevent the weld from cracking. Preheating can extend the heat-affected zone 800 -500 ` C temperature interval cooling time, welded joints from just solidified high temperature to room temperature cooling process, the metallurgical organisation will change, austenite from 800 ` C to begin to occur when the cooling is slower, the transformation into ferrite and pearlite or quartzite, which avoids the emergence of martensite hardened organisation, improves the welded joints resistance to cracking, so as to avoid welded Cracks.

low alloy steel pipe

(3) preheating can reduce welding stress. Preheating (local preheating or overall preheating) can reduce the temperature difference between the welding area and the overall temperature of the weldment (also known as the temperature gradient), the smaller the value of this temperature difference, the welding area and the weldment structure of the temperature inhomogeneity between the smaller, and as a result, on the one hand, reduces the welding stress, on the other hand, reduces the weld strain rate, and is conducive to avoiding weld cracks. When welding the welded joint area with large constraints, due to rapid cooling and heating, it will produce shrinkage stress in the joint area, which will cause cracks. Preheating the joint area before welding will reduce the shrinkage stress and prevent cracks.

(4) Preheating can reduce the constriction of the welded structure, which is particularly obvious for reducing the angular joint constriction, and as the preheating temperature increases, the crack rate decreases.

(5) preheating can also remove oil, moisture and other factors affecting the quality of the weld, but also to promote the escape of hydrogen in the weld, thus preventing the production of porosity and other defects play a corresponding role, but also to prevent the production of cracks.

  • the method of preheating before welding:

In the workshop or field, can be used flame heating (air fuel or acetylene fuel), resistance heating, electronic induction heating and other methods of preheating. Regardless of what method, preheating must be uniform, unless there are special requirements, or preheating to penetrate the entire thickness of the weldment.

alloy welded pipe

Above is the purpose and method of alloy steel preheating before welding for you, if you need to buy alloy steel pipe, please feel free to contact us, we will quote for you in time.