Differences Between Stainless Steel And Carbon Steel
Feb 23, 2024
Stainless steel and carbon steel belong to steel, but because it contains other elements are different, so there is a difference in nature, usually only contains carbon elements of steel is known as carbon steel, while the stainless steel contains other alloy materials, it's corrosion, wear resistance is very good, the difference between the two are mainly the following four points:
1, different density
The density of carbon steel is slightly higher than ferritic and martensitic stainless steel, and slightly lower than austenitic stainless steel.
2, different composition
Stainless steel (Stainless Steel) is the abbreviation of stainless acid-resistant steel, air, steam, water and other weak corrosive media or stainless steel is called stainless steel; and will be resistant to chemical corrosive media (acids, alkalis, salts, and other chemical impregnation) corrosion of the steel is called acid-resistant steel.
Carbon steel is an iron-carbon alloy with a carbon content of 0.0218% to 2.11%. Also called carbon steel. Generally also contains a small amount of silicon, manganese, sulfur, phosphorus.
3, resistance is different
Resistivity according to carbon steel, ferritic type, martensitic type and austenitic type stainless steel sort of increasing.
4, different coefficients of expansion
Coefficient of linear expansion of the size of the order is similar, the highest austenitic stainless steel and carbon steel is the smallest.
5, different magnetic
Carbon steel, ferritic and martensitic stainless steel is magnetic, austenitic stainless steel is non-magnetic, but its cold work hardening generates a martensitic phase transition will produce magnetic, available heat treatment methods to eliminate this martensitic organisation and restore its non-magnetic.

- Which is harder, stainless steel or carbon steel?
Generally speaking, the hardness of carbon steel is higher, because it contains more carbon, but the disadvantage is that it is easy to rust. Of course, the specific hardness also need to look at the grade, and we need to pay attention to is not the higher the better hardness, because the harder the material means that the more likely to break, while the hardness of the low, the toughness is good, not easy to break.








