How to make pre-galvanized pipe
Oct 09, 2024
1. Purpose of degreasing:
Remove oil, fat and other organic pollutants on the surface of the steel pipe, which will affect the subsequent pickling effect.
Method: Usually use alkaline solution or organic solvent for degreasing. After degreasing, rinse with clean water to prevent residue.
2. Purpose of water washing: Remove chemical substances remaining on the surface of the steel pipe during the degreasing process to prevent affecting subsequent processes.
Method: Generally use running water or spray water to rinse the surface of the steel pipe.
3. Purpose of pickling: Remove rust, scale and other inorganic pollutants on the surface of the steel pipe to make the surface of the steel pipe clean and smooth.
Method: Usually use hydrochloric acid or sulfuric acid solution for pickling. The pickling time depends on the degree of rust and the thickness of the scale of the steel pipe. During the pickling process, the concentration and temperature of the solution should be controlled to prevent excessive corrosion of the steel pipe substrate caused by over-pickling.
4. Purpose of water washing: Rinse off the acid residue on the surface of the steel pipe to prevent the acid residue from causing corrosion on the surface of the steel pipe.
Method: Generally use a large amount of clean water to rinse.

5. Purpose of passivation: to form a passivation film on the surface of the steel pipe after pickling, to slow down the reoxidation rate of the steel pipe surface, and to ensure that the steel pipe is not easy to rust again in the subsequent process.
Method: chemical agents can be used for passivation treatment to form a stable chemical film on the surface of the steel pipe.
6. Purpose of auxiliary plating: auxiliary plating treatment before galvanizing is to form a uniform protective film on the surface of the steel pipe to prevent the steel pipe from oxidizing when it comes into contact with air in the galvanizing tank.
Method: The steel pipe is soaked in zinc chloride or ammonium chloride solution to form an auxiliary plating film on the surface. The surface of the steel pipe after auxiliary plating can better combine with the zinc liquid, thereby improving the adhesion of the galvanized layer.
7. Purpose of drying: to ensure that the surface of the steel pipe is dry before the steel pipe enters the galvanizing tank, to prevent the moisture in the auxiliary plating solution from entering the zinc pot, and to prevent the zinc liquid from splashing or unevenly adhering.
Method: hot air drying, natural air drying and other methods can be used for treatment.








