What’s The Difference Between 316L And 904L
Nov 08, 2023
What’s The Difference Between 316L And 904L
Both 904L and 316L are austenitic steels, non-magnetic, with high corrosion resistance, as well as good machining and polishing properties. It is known that in some cases they can be considered substitutes for each other. So what's the difference?
Grade 316L is a lower carbon version of 316 and is highly resistant to sensitization (grain boundary carbide precipitation) and is therefore widely used in large format welded components. The lower carbon content of 316L makes it more resistant to corrosive environments than 316 stainless steel. Austenitic stainless steel 904L is a low-carbon high-alloy austenitic stainless steel with good machinability and weldability as well as resistance to corrosion by dilute sulfuric acid. The addition of copper gives it strong acid resistance, especially resistance to chloride gap corrosion and stress corrosion.
Chemical composition is the key to studying and determining the physical properties of 316L and 904L. We have listed the chemical compositions of the two analytical SS grades we are working on in the table below.
|
Grade |
C |
Mn |
Si |
P |
S |
Cr |
Mo |
Ni |
Cu |
|
316L |
0.03 |
2.0 |
0.75 |
0.045 |
0.030 |
16.0-18.0 |
2.00-3.00 |
10.0-14.0 |
/ |
|
904L |
0.02 |
2.0 |
1.00 |
0.035 |
0.035 |
19.0-23.0 |
4.0-5.0 |
23.0-28.0 |
1.0-2.0 |

As can be seen from the table above, 316L and 904L steel have similar chemical compositions in terms of C, Si, and Mn content, but the chromium, nickel, molybdenum and other alloy contents of 904L steel are much higher than 1.6 times that of 904L steel. 316L and 904L steel contain a certain amount of copper, which can effectively delay the corrosion of stainless steel by acidic liquids, especially chlorides, making 904L steel more corrosion-resistant and wear-resistant than 316L. Additionally, 904L is much more tolerant to chlorides at elevated temperatures. If 904L has better corrosion resistance, can I use 904L instead of 316L? The answer is no! The higher nickel content of 904L makes it an expensive part, which will impact the overall cost.
There is no difference in strength and hardness between 316L and 904L steel. The Rockwell hardness (HRB) of the two is similar, both are less than 95, and the tensile strength is around 490MPa. These properties are specified in ASTM A240/A240M for flat-rolled products (plate, sheet, and coil). Pipe and rod have similar specifications but are not necessarily assigned the same properties.








