What is the hardness of ASTM A335 P91 alloy pipe

Jul 09, 2025

According to the technical specifications and engineering practices of ASTM A335 P91 alloy pipes, its hardness standards and key points are as follows:

 

‌Standard hardness range‌
‌Brinell hardness (HB): Usually controlled in the range of ‌250 HB–280 HB‌ to ensure that the material has both wear resistance and processing feasibility.
‌Upper limit‌: The hardness after heat treatment shall not exceed ‌250 HB‌ (some standard requirements) to avoid brittleness risks.

 

Analysis of abnormal hardness causes‌
‌Surface decarburization‌
The loss of carbon elements during high-temperature heat treatment leads to the formation of ferrite structure on the surface, and the hardness ‌drops sharply to below 150 HB‌ (originally ≥250 HB).

The decarburized layer needs to be confirmed by metallographic testing (such as EN 10216-2 standard).
‌Small-diameter pipe wall effect‌
The cooling rate of thin-walled pipes (such as power plant drain pipes) is too fast, which may generate non-martensitic structure and cause uneven hardness distribution.

A335 P91 alloy steel pipe for high pressure

Quality control measures
Testing methods: Pre-screening with ultrasonic or eddy current flaw detection, and then multi-point Brinell hardness test on suspected areas (avoiding decarburized layer).
Composition guarantee: Strictly control the nitrogen-aluminum ratio (N/Al≥4) to maintain the precipitation strengthening effect.
 

Consequences of unqualified hardness
High temperature endurance strength attenuation: If the hardness is lower than 200 HB, the endurance strength at 620℃ may decrease by ≥30%.
Accelerated creep failure: When the pipeline is in service under supercritical conditions (≥580℃), creep cracking is prone to occur preferentially in the low hardness area.
Note: If abnormal hardness is detected during on-site acceptance (such as <200 HB), it is necessary to combine chemical composition analysis with metallographic re-examination to avoid misjudgment of qualified pipes.

SA335 P91 heat exchanger tube

GNEE Group has a professional R&D team of more than 20 people, and is equipped with advanced and complete production equipment and testing equipment to provide you with test reports to ensure the quality of steel pipes. With high-quality alloy steel pipes, GNEE Group has more than 8,000 partners around the world. If you need high-quality alloy pipes, we can provide you with alloy pipes of ASTM, ASME, DIN, EN and other standards to meet your project needs and provide technical support.